Earlier this year, the Kentucky Transportation Cabinet (KYTC) made plans to widen US-31 East in Larue County, Kentucky. The project included softening a sharp curve as well as reinforcing an eroded stream bank below the roadway.
To accomplish this, the project required two retaining walls to support the roadway. Bo Warren, PE is a Transportation Engineering Supervisor for the Kentucky Transportation Cabinet, and he explained that "it was important for these walls to be gravity structures because of the close proximity to the existing traffic flow and the requirement to have one lane of traffic flowing during construction. If the walls had been tieback walls, the whole road would have to be shut down for excavation until the walls were built."
Knowing that the solution needed to be gravity, designers turned to Redi-Rock® from local manufacturer Redi-Rock of Kentuckiana. Redi-Rock is known for building tall walls that require no reinforcement, using massive 41 inch (1030 millimeter) deep precast gravity blocks weighing as much as a Budweiser Clydesdale. This particular project also utilized Redi-Rock 60 inch (1520 millimeter) base blocks, which weigh as much as a Corvette.
Using these massive blocks allowed the project to:
Over the course of this project, the general contractor Salsman Brothers lost approximately four weeks due to bad weather. "The wall installation wasn't affected by the bad weather though. We could keep working on the walls when we couldn't do anything else. This helped us get traffic open before the project's completion date," explained David Woford, PE of Salsman Brothers. "Versus conventional cast in place retaining walls, Redi-Rock probably saved us about 15 days," Woford said.
Below the walls lie a creek that floods during large storm events. "We had to do a rapid drawdown analysis on the walls and that's what controlled the global stability," explained wall design engineer, Clint Hines, PE of JC Hines and Associates. "There were also a couple of pipe penetrations through the walls, so the Redi-Rock walls really act as the headwalls." Above the walls is a 2:1 crest slope that is 5 feet (1.5 meters) tall, then the road shoulder, a guard rail, then the widened lane of US 31.
"It looks good and it functions well. Installation went well; after the first course of blocks was installed, the rest just flew in," Warren said.
In total, the project included two gravity walls in the Redi-Rock Cobblestone texture; the first wall stood 13.5 feet (4.1 meters) tall and extended for 352 feet (99.1 meters) and the second wall stood 12 feet (3.7 meters) tall and extended 406 feet (123.7 meters).
Project: New Haven-Hodgenville Rd. (US-31E) Curve Repair & Rehab - #159 Customer: Kentucky Transportation Cabinet Engineer: Clint Hines, PE of J.C. Hines and Associates Manufacturer: Redi-Rock of Kentuckiana Installer: Redi-Rock of Kentuckiana Location: Larue County, Kentucky Year Built: 2013
Gravity Retaining Wall Blocks - Massive, one-ton Redi-Rock gravity blocks rely on the sheer mass of each block to hold back the earth.
Cobblestone Texture - Redi-Rock Cobblestone blocks feature a great stacked stone aesthetic with the appearance of six smaller blocks.
Your local retailer is
at Redi-Rock International.
Call or email .
There are over 130 Redi-Rock manufacturers around the world. Enter your project's postal code to find your closest retailer.
Still can't find what you're looking for?